[avrdude-dev] [bug #16156] Problem with Si-Prog

[anonymous]

URL:
  <http://savannah.nongnu.org/bugs/?func=detailitem&item_id=16156>

                 Summary: Problem with Si-Prog
                 Project: AVR Downloader/UploaDEr
            Submitted by: None
            Submitted on: Срд 22.03.2006 at 17:04
                Category: None
                Severity: 3 - Normal
                Priority: 5 - Normal
              Item Group: None
                  Status: None
                 Privacy: Public
             Assigned to: None
         Originator Name: RmRm
        Originator Email: address@hidden
             Open/Closed: Open

    _______________________________________________________

Details:

I use AVRdude in WinAVR (editor Programmers Notepad-2) with consecutive
adapter SiProg (COM-port). Controllers AVR are programmed normally. However
at end of programming on line RES send a low level (RES=0) and the controller
is not started, therefore it is necessary to disconnect physically SiProg from
a controller. It is necessary to make in AVRdude so that upon end of
programming on lines of COM-port high level RES=1 has been established. 




    _______________________________________________________

Carbon-Copy List:

CC Address                          | Comment
------------------------------------+-----------------------------
r1973r --СБК-- yandex --ТЧК-- ru | Originator Email




    _______________________________________________________

Reply to this item at:

  <http://savannah.nongnu.org/bugs/?func=detailitem&item_id=16156>

_______________________________________________
  Message sent via/by Savannah
  http://savannah.nongnu.org/