[avrdude-dev] jtagmkii not working for me

[Emil]

I have a JTAGICE MKII serial interface which works fine with
avarice but fails with avrdude. Both programs use the serial
interface at 19200 bauds.

$ avrdude -P /dev/ttyS0 -c jtagmkii -p m128 -vvv

avrdude: Version 5.0
         Copyright (c) 2000-2005 Brian Dean, http://www.bdmicro.com/

         System wide configuration file is "/etc/avrdude.conf"
         User configuration file is "/home/emil/.avrduderc"
         User configuration file does not exist or is not a regular
file, skipping

         Using Port            : /dev/ttyS0
         Using Programmer      : jtagmkii
avrdude: jtagmkII_open()
avrdude: jtagmkII_getsync()
avrdude: jtagmkII_getsync(): Sending sign-on command: 
avrdude: jtagmkII_send(): sending 1 bytes
avrdude: jtagmkII_recv():
avrdude: ser_recv(): programmer is not responding
avrdude: jtagmkII_recv(): Timeout receiving packet
avrdude: jtagmkII_getsync(): sign-on command: status -1
avrdude: jtagmkII_getsync(): Sending sign-on command: 
avrdude: jtagmkII_send(): sending 1 bytes
avrdude: jtagmkII_recv():

$ avarice --jtag /dev/ttyS0
AVaRICE version 2.3, Oct  6 2005 17:31:43

Defaulting JTAG bitrate to 1 MHz. Make sure that the target
frequency is at least 4 MHz or you will likely encounter failures
controlling the target.

JTAG config starting.
Hardware Version: 0xc0
Software Version: 0x78
Reported JTAG device ID: 0x9702
Configured for device ID: 0x9702 atmega128
JTAG config complete.


-- 
                                                                Regards,
                                                                Emil
--
Don't walk on the grass, smoke it.