[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[PATCH 0/5] hw/arm/smmuv3: Correct stream ID and event address handling
From: |
Simon Veith |
Subject: |
[PATCH 0/5] hw/arm/smmuv3: Correct stream ID and event address handling |
Date: |
Wed, 4 Dec 2019 14:55:43 +0100 |
While working on the Linux SMMUv3 driver, I noticed a few cases where the QEMU
SMMUv3 behavior relating to stream tables was inconsistent with our hardware.
Also, when debugging those differences, I found that the errors reported through
the QEMU SMMUv3 event queue contained the address fields in an incorrect
position.
These patches correct the QEMU SMMUv3 behavior to match the specification (and
the behavior that I observed in our hardware). Linux guests normally will not
notice these issues, but other SMMUv3 driver implementations might.
Simon Veith (5):
hw/arm/smmuv3: Apply address mask to linear strtab base address
hw/arm/smmuv3: Check stream IDs against actual table LOG2SIZE
hw/arm/smmuv3: Align stream table base address to table size
hw/arm/smmuv3: Use correct bit positions in EVT_SET_ADDR2 macro
hw/arm/smmuv3: Report F_STE_FETCH fault address in correct word
position
hw/arm/smmuv3-internal.h | 4 ++--
hw/arm/smmuv3.c | 39 ++++++++++++++++++++++++++++++++-------
2 files changed, 34 insertions(+), 9 deletions(-)
--
2.7.4