Hi,
After some more trials and errors, I think I have got most of it right;
- simulations are working fine - with yellow dots when trigger goes active,
- ground testing appears to work; I can get one of the physical led to blink periodically, (yellow dots and all).
- I also think I have located the correct pins to physically connect the trigger wires to, (IRV, IRH1, IRH2 or ADC4) .
But still, I can't measure any current when the trigger goes active, measuring between both gnd/+3,3V and all the rest of the analog pins.
Any suggestions?
Cheers,
Jorn