Hi Helge,
the extra noise is from reading the lower three bits of the pressure
result wrongly. They are in the higher bits of the XLSB, not the
lower, fixed in master:
@@ -130,7 +130,7 @@ void baro_bmp_event( void ) {
/* get uncompensated pressure, oss=3 */
bmp_up = (bmp_trans.buf[0] << 11) |
(bmp_trans.buf[1] << 3) |
- bmp_trans.buf[2];
+ (bmp_trans.buf[2] >> 5);
/* start temp measurement */
bmp_trans.buf[0] = BMP085_CTRL_REG;
bmp_trans.buf[1] = BMP085_START_TEMP;
Thanks for looking into that.
As the max conversion time is 25.5ms it could be run at 30Hz without
changes, maybe having the temp reading only once per second as
suggested in the spec. Some averaging could be done depending on the
frequency you need.
Martin
http://paparazzi.enac.fr/wiki_images/Bmp085_scp1000.png
http://paparazzi.enac.fr/wiki_images/Bmp085_scp1000_fixed.png
On 04.08.2011 11:36, Helge Walle wrote:
Hi,
To make sure that the sample rate is not set so high that it interferes
with the conversion time of the BMP sensor, I would need to check the
data flow with my logic analyzer.
I did not do that yesterday evening. However, Increasing freq from "8"
to "20" in .../paparazzi/conf/modules/baro_bmp.xml increased the data
flow and did not create any problems.
The code I used with my Arduino board that made better results was from
Sparkfun. I am quite determined to work through the code since I feel
sure that this is the right way to go.
Regards,
Helge.
_______________________________________________
Paparazzi-devel mailing list
address@hidden
https://lists.nongnu.org/mailman/listinfo/paparazzi-devel