[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Paparazzi-devel] 3 state switch on any R/C controller
From: |
Andrew S |
Subject: |
Re: [Paparazzi-devel] 3 state switch on any R/C controller |
Date: |
Sat, 30 May 2009 21:08:07 +0400 |
Hello
try to add two resistor divider between switch inputs. this would give central
position.
30.05.09, 17:04, "? flying pig" <address@hidden>:
> Hi there
>
> I have recently got one of the remote controll from someone, it is 4
> channel 40Mhz, the brand is REELY (from Conrad in Germany i believe). I was
> thinking using for paparazzi.
>
> I have tap in to the R/C receiver, which was ok (just read the chip number
> without any measurement), however, I have some didfficulty in making 3 state
> switch.
>
>
> I cut the yaw channel (4th channel), and rewire to 3 state switch
> (on/off/on), however, when i use it, it seen like only have on/off function.
>
>
> Does anyone has done the similar thing about cutting one channel from the
> controller to make it into the 3 state switch? can anyone advice?
>
>
>
> Regards
>
>
> Chen
> 5 GB ???? ????????????????? — ???? Windows Live Hotmail
--
Есть ли письма? Знает мобильная Яндекс.Почта http://mobile.yandex.ru/online