I've finally gotten Linphone compiled and installed. However, I've tried to run it both from the GUI and linphonec, but it's not working. From the GUI, Linphone crashes as it opens. From linphonec, these are the errors I'm getting:
~/linphone $ linphonec
ALSA lib conf.c:4687:(snd_config_expand) Unknown parameters 0
ALSA lib control.c:951:(snd_ctl_open_noupdate) Invalid CTL default:0
ALSA lib conf.c:4687:(snd_config_expand) Unknown parameters 1
ALSA lib control.c:951:(snd_ctl_open_noupdate) Invalid CTL default:1
ALSA lib pcm_dmix.c:1018:(snd_pcm_dmix_open) unable to open slave
-unknown source-(1) : error 10 : Missing token, at offset -1
near [Index: 0 (Start: 0-Stop: 0) ='<missing '@'>', type<24> Line: 1 LinePos:18]
: Missing '@'
ortp-error-header_address parser error for [sip:
sip.linphone.org]
ortp-error-Cannot create LinphoneAddress, bad uri [sip:
sip.linphone.org]
Warning: The sip proxy address you entered is invalid, it must start with "sip:" followed by a hostname.
Ready
Warning: video is disabled in linphonec, use -V or -C or -D to enable.
linphonec> ortp-error-Connection failed for fd [7]: cause [Connection refused]
ortp-error-Cannot connect to [TCP://
50.12.62.103:50004]
ortp-error-presence_process_io_error not implemented yet
-memory-(1) : error 10 : Missing token, at offset 37
near [Index: 0 (Start: 0-Stop: 0) ='<missing '@'>', type<24> Line: 1 LinePos:37]
: Missing '@'
Segmentation fault
Any guidance on troubleshooting this will be greatly appreciated.