Von: Sam Geeraerts <address@hidden>
An: gNewSense <address@hidden>
Gesendet: 14:44 Sonntag, 17.Juli 2011
Betreff: Re: [gNewSense-users] How connect to my WinXP-Home machine with firewall?
Snoopys Woodstock wrote:
> gNewSense does not block any network traffic by default.
>
> Right because the firewall isn't actiated by default. Or did I
missunderstood something?
You could say that it's not activated.
> You can check your firewall settings by running "sudo iptables -L" in a terminal.
>
> This is the output of "sudo iptables -L":
> Chain INPUT (policy ACCEPT)
> target prot opt source destination
> Chain FORWARD (policy ACCEPT)
> target prot opt source destination
> Chain OUTPUT (policy ACCEPT)
> target prot opt source destination
> but I don't unterstand it.
You can think of iptables as the "raw" firewall. ufw is an easier front-end. This shows that everything is open (firewall is disabled). I assume you have set ufw to "default deny".
Right
To enable access to
shared folders you probably have to enter "sudo ufw allow 445/tcp". I've updated the ports table on the wiki.
When I activate the ufw and allowed the 445/tcp then I got a failure message. I've attached an screenshot. thanks
_______________________________________________
gNewSense-users mailing list
address@hiddenhttps://lists.nongnu.org/mailman/listinfo/gnewsense-users
Screenshot.png