Hello all:
Regarding the signal amplification:
- Amplifiers CAN improve the SNR, when used properly. The idea is to minimize the noise figure of the receive chain by putting a good LNA and filters (prevents LNA overload) in front of the chain (Friis
law for noise). Since wideband SDRs often do not have great Rx frontend (claimed noise figures are often not met in real-world environments, due to the lack of preselector filtering), these amplifiers in active GNSS antennas do actually improve the
signal quality.
- That said, the gain level of such amplifiers is not that important (as long as the level is somewhere around 20 - 30 dB). Their noise figure is. Unfortunately, sellers and manufacturers often do not publish the typical noise
figure of the circuits.
- Still (as mentioned several times already), you are probably not going to see the real signals on your spectrum plot. Matched filtering is necessary
(or maybe cyclostationary detectors?) . Using simulated signals is not a bad idea, I think, since that would make debugging a bit easier.
Regards,
Kyeong Su Shin
보낸 사람: It's a cat <luoshumymail@gmail.com> 대신 discuss-gnuradio-bounces+ksshin=postech.ac.kr@gnu.org <discuss-gnuradio-bounces+ksshin=postech.ac.kr@gnu.org>
보낸 날짜: 2023년 3월 1일 수요일 오후 10:55
받는 사람: David Dima <daviddimavd@gmail.com>
참조: GNURadio Discussion List <discuss-gnuradio@gnu.org>
제목: Re: Galileo Frequency Shifting and Filtering
Amplifier only increase power (signal plus noise), they can't give you better SNR.
Anyway, It's much better to use a CW signal generator to help you debug the frequency converter chain (remember to keep output power low, e.g. -60dBm). You can use freq sink to check every stage of your flowgraph, and use Range / slider widget to control
block parameters to search and check. If the signal disappears, or the passband doesn't meet your requirement, the problem can be easily located.
Hi,
Sure, but the power of this kind of signals is below noise level. Current antenna amplifies 30dB but it still not enough to see anything in the spectrum (I have checked it alredy).
Regards,
David
If you have a signal generator, GNSS simulator or a high gain antenna, you can verify your settings by adding a spectrum display (Qt Freq Sink) or something like that to your receiver path.
Because many things can go wrong in your setup, if you misunderstand something. Just try to verify this directly. If there's a signal you should be able to see it on the spectrum display.
Hi guys,
I am trying to simultaneously record Galileo's E5a and E5b signals as follows:
I have tried to record them separately by tuning the local oscillator in the middle of the signals bandwidths and sampling at 25MHz and it worked. But when I try to shift and filter to get the signals in a different file, it does not work. I have no idea
what am i doing wrong.
Galileo's Signal Plan is as follows:
|