Hi Marcus
Curiosity and quickness possessed me. I tried first to burn it with the usrp_n210_r4_fpga.bit as I have a N210 but it failed. Later, I could burn it with the usrp_n200_r4_fpga.bit. I changed the Ip and installed the usrp_n200_fw.bin and usrp_n200_r4_fpga.bin. It could recognize it. My FPGA is a Spartan 3 XC3SD1800A.
EnvironmentError: OSError: error in pthread_setschedparam
_____________________________________________________
/
| Device: USRP2 / N-Series Device
| _____________________________________________________
| /
| | Mboard: N???
| | mac-addr: 00:00:00:00:40:00
| | ip-addr: 192.168.10.3
| | subnet: 0.0.0.104
| | gateway: 255.255.255.255
| | gpsdo: none
| | serial: 0
| | FW Version: 12.4
| | FPGA Version: 11.1
| |
| | Time sources: none, external, _external_, mimo
| | Clock sources: internal, external, mimo
| | Sensors: mimo_locked, ref_locked
The problem is when I run the ./test_pps_input from the uhd my USRP fails finding the PPS.
Please see the general application notes in the manual for instructions.
EnvironmentError: OSError: error in pthread_setschedparam
Error: RuntimeError: Board 0 may not be getting a PPS signal!
No PPS detected within the time interval.
See the application notes for your device.
What could be the problem? Maybe the firmware? I'm not completely sure about it
Any help or advice will be appreciate
Regards
Isaac T.