|
From: | Dobler, Anton |
Subject: | USRP, GPIO toggling and Gnuradio |
Date: | Fri, 10 Sep 2021 14:18:19 +0000 |
Dear all,
I am currently trying to write an OOT block to switch a GPIO pin high or low depending on the input signal. So far it has worked with the configuration of the pins and I can also switch the pins according to the input signal in a relatively simple flowgraph
consisting of a signal generator that produces a square wave signal.
The block's work function looks like this:
int GPIO_IO_impl::work(int noutput_items,
gr_vector_const_void_star &input_items,
gr_vector_void_star &output_items)
{
const float *in_signal = (const float *) input_items[0];
for(int i=0; i < noutput_items; i++) {
if(in_signal[i] >= d_threshold)
{
_dev->set_gpio_attr(gpio, std::string("OUT"), "HIGH", 0xffffffff)
}
if(in_signal[i] < d_threshold)
{
_dev->set_gpio_attr(gpio, std::string("OUT"), "LOW", 0xffffff);
}
boost::this_thread::sleep_for(boost::chrono::nanoseconds((unsigned long long)d_samp_period));
}
return noutput_items;
}
The sleep function is important in that without it, regardless of the sampling rate of the square wave signal, the pin is switched with a period of 20us. If I use the sleep function, the whole thing works better, but only up to a sampling rate of about
20kHz. I have read a little bit about the function of the scheduler in GNURadio, but I did not find a solution.
Starting from the standing approach, I have tried using both Timed Commands and Boost Signals, with the result that the pins are switched completely asynchronously. Since I don't really know what to do at this point, I wanted to ask if any of you had experience
with this kind of OOT block in GNURadio.
Best regards,
Anton
|
[Prev in Thread] | Current Thread | [Next in Thread] |