eth1 Link encap:Ethernet HWaddr 34:17:eb:a5:5a:f1
inet addr:192.168.10.1 Bcast:192.168.10.255 Mask:255.255.255.0
inet6 addr: fe80::3617:ebff:fea5:5af1/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:38828790 errors:0 dropped:0 overruns:0 frame:0
TX packets:37442520 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:55487116438 (55.4 GB) TX bytes:45938732293 (45.9 GB)
Interrupt:20 Memory:f7d00000-f7d20000
USRP add was changed to .3. One more thing to mention going back to flow graph, the unpack k bits block if K set to 8 then i guess in this case I'm comparing bit by bit since K was mentioned in document to unpack bytes to bits according to the set k value. The BER gives 0.0078 after changing K, bits per symbols and unpacked to packed while bypassing the delay block. After simulating the same setup without the USRP i found 0.0075 BER instead of zero!! since there was no error introduced in the simulation.
Any suggestion ?
Thank you