|
From: | Jorge Gallo |
Subject: | Re: [Discuss-gnuradio] Flush samples of blocks when changing centrer frequency |
Date: | Thu, 5 Feb 2015 12:12:12 +0100 |
On Thu, Feb 5, 2015 at 11:30 AM, Jorge Gallo <address@hidden> wrote:Hi,I have a python flowgraph with several blocks.One of them is a "filter.single_pole_iir_filter_ff" which does a moving average. The last block is a Sink to file block.I scan several bands, 10MHz each, in order to get the power of the signals in those bands. I use moving average to get an average of 5 readings in each band.In order to change the center frequency, I stop the flow-grahp, reconfigure the USRP center freq and then start the flow-graph again.You can use the message port[1] in uhd source/sink or stream tags [2] to change the center frequencyI guess samples from the previous scans remain in internal block buffers since I get power in samples of BAND2 (BAND1+10MHz) which are only present in BAND1. That is, the moving average is effective between bands and I only want to be effective in the same band.I thought that stop() and start() signals would reset the entire graph but I am afraid it doesn't.Is there a way to flush those samples so that everytime I run the frequency changed flow-graph I don't get the samples from the previous band?UHD source will give rx_time, rx_rate and rx_freq tags whenever there is a tune request to a new frequency. You can use these tags to get rid of unwanted samples.Many thanks in advance.Jorge[1] http://gnuradio.org/doc/doxygen/page_uhd.html
[2] https://github.com/gnuradio/gnuradio/blob/master/gr-uhd/examples/python/freq_hopping.py
_______________________________________________
Discuss-gnuradio mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/discuss-gnuradio
--
[Prev in Thread] | Current Thread | [Next in Thread] |