|
From: | Syed Aqeel Raza |
Subject: | Re: [Discuss-gnuradio] Video Streaming Issue (most probably at receiving end) |
Date: | Tue, 4 Feb 2014 15:15:33 +0800 |
Hi,Again, I did some more work and the details are as under.
1. I have created a single flowgraph without USRP hardware. For your reference the file is enclosed with the name of gmsk_file_transceiver.grc. This work fine and we can see the stream video output without any difficulty.
2. To continue further I splitted the above mentioned file into transmitter and receiver side along with the inclusion of USRP source and sink blocks, respectively. Their flowgraphs are enclosed with the name of gmsk_tx.grc and gmsk_rx.grc, respectively. The FFT plot shows that (vdo transmission.png enclosed) transmitter and receiver handshakes with each other but the signal difference between the transmitter and the receiver side is 80 dB. I further noticed that whenever I stopped the transmission the received signal at the receiver further drops to -120 dB.
I really get stuck in this issue for the last two days. I need your assistant to resolve this problem as I am a newbie in gnuradio using USRP platform.Thanks in advance.
Regards,
Syed Aqeel Raza
On Sat, Feb 1, 2014 at 11:36 AM, Syed Aqeel Raza <address@hidden> wrote:
Hi Martin,Thanks for your reply.I have made some changes in the flowgraphs due to which the transmitter and receiver sides handshakes with each other. Despite of this handshaking, the receiver side is not produced the required baseband signal. Furthermore, I have designed a single flowgraph that comprises on transmitter and receiver without the inclusion of USRP source and sink block. That single flowgraph works fine and perfectly streaming the video.I will send the updated flowgraphs to you by tomorrow.Regards,Syed Aqeel RazaOn Sat, Feb 1, 2014 at 8:05 PM, Martin Braun <address@hidden> wrote:
On 30.01.2014 18:17, Syed Aqeel Raza wrote:How did you test the transmitter?
I have checked the transmission part, which is working perfectly by
transmitting a video stream over the wireless. Whereas, no video
reception is displayed on receiver end.
There's many things that can go wrong here. Does your rx spectrum look good?
For further reference, I have attached the flow charts used for
transmission and reception of video streaming. An earliest reply is
highly appreciated.
MB
[Prev in Thread] | Current Thread | [Next in Thread] |