Dear all,
I need to send data from the OMAP3 to the Spartan3an FPGA. As I understand ,from the wiki and presentations, there are two ways to communicate namely; using setting_reg and GPIO. The second way seems easier so I'll try it first.
I intend to set or clear the free GPIOS on the
Spartan FPGA such as over_gpio_22. I added the following code to the example tx_waveforms.cpp.
static struct gpio gpio_test = { 22, GPIOF_OUT_INIT_LOW, "OVERO_GPIO_22" };
gpio_set_value(22,1);
//set gpio22 which is connected to pin IO_L30N_0
I tried to compile then I got the error that can't find GPIO.h.
My question: did I use the correct high level function or I used a "lower level" that is used to implement the
function?
Regards,
S. Yassin