Snips from terminal output:
./configure --enable-usrp
--enable-gr-usrp
configure: Using LIBUSB version 'libusb'
checking
for sdcc... sdcc -mmcs51 --no-xinit-opt
checking for asx8051...
no
USRP requires sdcc version 2. sdcc not found. See http://sdcc.sf.net
Unable to
find firmware compiler SDCC.
configure: error: Component usrp has errors;
stopping.
sdcc -v
SDCC :
mcs51/gbz80/z80/ds390/pic16/pic14/TININative/ds400/hc08 3.0.0 #6037 (Mar 20
2011) (Linux)
I suspect this is the problem, 2 vs 3?
Another snip from terminal
output:
./bootstrap
./configure
config.status: executing depfiles
commands
*********************************************************************
The
following components were skipped either because you asked not
to build
them or they didn't pass configuration checks:
usrp2-firmware
These components will not be built.
*********************************************************************
The
following GNU Radio components have been successfully
configured:
config
gruel
volk
gnuradio-core
usrp2
gr-usrp2
gr-msdd6000
gr-audio
gr-atsc
gr-cvsd-vocoder
gr-gsm-fr-vocoder
gr-noaa
gr-pager
gr-radio-astronomy
gr-trellis
gr-video-sdl
gr-wxgui
gr-qtgui
gnuradio-examples
grc
docs
You my now run the make command to build these components.
*********************************************************************
The
following components were skipped either because you asked not
to build
them or they didn't pass configuration checks:
gcell
usrp
gr-usrp
gr-gcell
gr-comedi
gr-gpio
gr-radar-mono
gr-sounder
gr-utils
gr-uhd
These components will not be built.
Configured GNU Radio release v3.4.0git-139-gf53fef3d for
build.
Patrik