On Wed, Mar 02, 2011 at 09:18:39PM -0500, Yan Nie wrote:
> Dear all,
>
> I'm using the message_source to generate the source, connecting it with a multiply_const block to configure the amplitude for the signal.
>
> The message_source is created by the following:
> data = "" 2)
This means your input items are 1 byte in length (=8 bit).
> msgq = data.msgq()
>
> When the msg is inserted as a tail of the msgq while the flow graph is running, the msg is inserted using insert_tail(msg). If my understanding serves me right, if only insert the msg once, it suppose to be send once. In my case, however, the msg is sent 10 times. (the set_amp is defined in the tb block to change the amplitude of the signal while tb is running) Could anyone help me to see what causes the problem?
> The code related msgq_insert in main thread is as followed:
> try:
> while 1:
> i = 1
> tb.set_amplitude(5000)
> msg_13bit = gr.message_from_string(payload_13bit)
Is msg_13bit really only 8 bits large? Have you checked the message sent
is what you wanted it do be?
> tb._ls.msgq.insert_tail(msg_13bit)
> tb.set_amplitude(0)
> while(i < 50)
> msg_stop = gr.message_from_string(payload_stop)
> tb._ls.msgq.insert_tail(msg_stop)
Same here.
> i += 1
>
> Really appreciate any of your help!
> Thanks,
> Yan
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
>
http://lists.gnu.org/mailman/listinfo/discuss-gnuradio--
Karlsruhe Institute of Technology (KIT)
Communications Engineering Lab (CEL)
Dipl.-Ing. Martin Braun
Research Associate
Kaiserstraße 12
Building 05.01
76131 Karlsruhe
Phone: +49 721 608-43790
Fax: +49 721 608-46071
www.cel.kit.edu
KIT -- University of the State of Baden-Württemberg and
National Laboratory of the Helmholtz Association