|
From: | Gabriel Morel |
Subject: | [Discuss-gnuradio] CRC error |
Date: | Tue, 08 Feb 2011 16:05:52 -0500 |
Hi, I try to run USRP2 with
my own binary file, and some lights would mean crc error. When I turn on
the USRP2, the F light is on and would mean PROGRAM_DONE, but the led D202 on
the board is also high but not suppose to. This light means the INIT_B pin
of the FPGA is low, and the datasheet of the FPGA told this pin is low when it
have a crc error: Figure27, page 50 of the Spartan-3 datasheet.
I tried to disable the crc
in the properties of "create programming file", but nothing
change.
I really have to create a
working binary file. Somebodies told me to call "make" in a terminal, but
I use a windows version of ISE. I included all file in all makefile.srcs
and I set all the properties listed in the makefile. Many engineer in the
ETS told me that is the same thing.
Can someone try the same
thing than me, or just tell me where I can modify the crc step?
Thanks
PS: I used ISE 10.1 and the
project in git://ettus.sourcerepo.com/ettus/fpga.git
|
[Prev in Thread] | Current Thread | [Next in Thread] |