On Mon, Oct 11, 2010 at 10:34 AM, Jorge Miguel <
address@hidden> wrote:
> My simple questions are:
> Does XCVR2450 work in full duplex mode?
Yes, although with one synthesizer, it will be on the same frequency
for rx and tx
> If yes: Does anybody know the isolation between tx and rx (Whole daughter
> board: transceiver,amplifier and RF switch) ?
I do not have full characterization for you, but it will be dominated
by the antenna switch (U2), you can find the datasheet here:
http://www.hw.com.tw/PDF/Switch/en/HWS383_v1.pdf
Looks like ~30dB at 2.4GHz
> If not: Does anybody know the time that XCVR2450 takes to switch from tx to
> rx state ?
It should be approximately the round-trip time for a control packet,
since you will not be tuning to a new frequency. However, because you
can do full-duplex, I doubt you need to switch.
Jason