[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] RXF2400 as receiver by using benchmark_rx.py, which w
From: |
蒲盟 |
Subject: |
[Discuss-gnuradio] RXF2400 as receiver by using benchmark_rx.py, which will receiver the signal(RX2 or TX/RX, or both) |
Date: |
Tue, 27 Jul 2010 22:40:11 +0800 (CST) |
Hi all,
I'm new in gnuradio and USRP, recently, when i run benchmark_rx.py, i found a problem which confused me a lot:
I use one USRP(equiped with a daughterboard of RFX2400, running benchmark_tx.py) as transmiter and another USRP (RFX2400 runing benchmark_rx.py) as receiver, as i only have one antenna, so i connect it to RX2 and run benchmark_rx.py at the receiver, as i expected, the result is nearly 100% "ok = true", but when i disconnect from RX2, it results some "ok = false", that is narmal.But again, i connect the antenna to TX/RX(not RX2), the result comes back to 100% "ok = true", i don't understand, could it be that when RFX2400 is used as a receiver, both TX/RX and RX2 receive the signal, if not ,how do they work?
I learned that if i want to select the rx antenna, i could use select_rx_antenna('RX2'), but even i did this ,it does nothing different.
i think MUX may be something related, but i'm not sure.
Any help will be appreciated.
您想拥有和网易免费邮箱一样强大的软件吗?
网易邮箱,没有垃圾邮件的邮箱。
您想拥有和网易免费邮箱一样强大的软件吗?