[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] High frequency OFDM
From: |
Joachim Roop |
Subject: |
Re: [Discuss-gnuradio] High frequency OFDM |
Date: |
Tue, 29 Jun 2010 15:49:37 +0200 |
> > Hi,
> >
> > I successfully implemented OFDM with two USRPs with LFRX/LFTX at
> 1-50MHz, connect by cable. Now I tried switching over to higher frequencies
> via
> TVRX/WBX. While I receive a perfectly valid looking spectrum with a good SNR,
> it does not seem to decode at >200MHz.
> > If I increase the sub-carrier spacing of the transmission and thus the
> bandwidth, it works again. But why do I have to do that if the signal and
> SNR look okay?
> >
> > What destroys a OFMD signal at high frequencies? Is it phase noise? Is
> the USRPs frequency resolution different at higher frequencies?
> >
> > Any literature/papers on this topic would also be helpful - I am kind of
> stuck here.
>
> It's probably due to the frequency offset. Since the local oscillator
> has a certain offset at its nominal frequency, that offset is
> multiplied when the signal is multiplied to a higher frequency. So the
> higher the frequency, the more you are offset. In the case of the OFDM
> signals, you are now farther off frequency than the lock-in range of
> the receiver.
>
> You already found one fix for this, which is making the subcarriers
> larger. The other thing to do is look at the frequency offset between
> the two devices and try to compensate for it.
>
> There was a discussion about this a few months ago that you can look
> for that explains a way to handle larger offsets better than the look
> and tune method, which, while it works, isn't a realistic solution.
>
> Tom
Thanks for the reply!
Sadly I already noticed and compensated for the frequency offset you mentioned
and manually centered the frequency block that OFDM consists of. I also
adjusted the respective levels, so clipping should not be an issue as well.
I just wonder why you can't use my OFDM configuration (that works perfectly at
low frequencies) at a higher frequency. My two USRPs are connected via cable
and the SNR and signal spectrum look good, so it should work, shouldn't it? :(
--
GRATIS für alle GMX-Mitglieder: Die maxdome Movie-FLAT!
Jetzt freischalten unter http://portal.gmx.net/de/go/maxdome01