[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] OFDM modulation/demodulation over USRP2
From: |
Veljko Pejovic |
Subject: |
[Discuss-gnuradio] OFDM modulation/demodulation over USRP2 |
Date: |
Wed, 13 Jan 2010 13:22:01 -0800 |
Hi,
I'm using Ubuntu 9.10, gnuradio version 3.2.2 and two USRP2 boards
with XCVR2450 daughter boards. The boards are about a meter apart from
each other.
I'm trying to get OFDM working over USRP2 boards and for that I'm
using GRC. I created a simple local loop (without USRPs):
signal_source->modulation->channel_model->demodulation->scope_sink. In
this case OFDM modulation/demodulation works fine. However, when I
split the loop into a sender signal_source->modulation->usrp2_sink and
a receiver: usrp2_src->demodulation->scope_sink the decoding does not
work, i.e. I don't get any output on the scope_sink. Although, FFT of
the usrp2_src output looks exactly like what OFDM should look like.
I'm pretty sure that the error is connected to OFDM as I got this
transmitter/receiver pair working with GMSK, for example.
I also tried the examples in
gnuradio-3.2.2/gnuradio-examples/python/ofdm which I had to tweak a
bit in order to get them using USRP2, but I got the same results:
there is an OFDM-like signal in the air, but it's not getting decoded.
Did anyone got OFDM demodulation working on USRP2? If so, any hints
are highly appreciated.
Thanks,
Veljko
- [Discuss-gnuradio] OFDM modulation/demodulation over USRP2,
Veljko Pejovic <=