[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] parallel data reception
From: |
Jason Uher |
Subject: |
Re: [Discuss-gnuradio] parallel data reception |
Date: |
Wed, 17 Jun 2009 09:28:25 -0500 |
> usrp_dual_source want antennas which should be used as input parameters, as
> follows (I copied this line from a question posted on a thread which was
> using LFRX daughter cards)
>
> self.usrp_dual_source_x_0 = grc_usrp.dual_source_c(which=0, side_a='A',
> rx_ant_a='RXA', side_b='A', rx_ant_b='RXB')
>
This is correct (assuming you are using GRC) The side A and side B
refer to the side of your usrp, not the ports on the RFX board itself.
Since you can have two daughter boards, the are side A ad B
respectively, you will have to use the rfx antenna select function to
choose between TX/RX and RX2.
If you are not using grc I have attached a file that I use to capture
data from two RFX2400 boards in the same usrp, it will probably
require some modifications for your application, but its a start.
Jason
multi_rfx_2400.py
Description: Binary data