[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] EEPROM warning
From: |
Woody Dickson |
Subject: |
Re: [Discuss-gnuradio] EEPROM warning |
Date: |
Tue, 17 Feb 2009 11:21:54 +0800 |
Hi,
I have one USRP board and 2 Flex900 boards. The Flex900 board has
both RX2 and TX/RX. I installed and screwed both Flex900 boards on
USRP motherboard and make sure all the holds are matched.
On the B side, I have Flex900 card.
What do you think could be the problem?
Thanks,
Woody
On Tue, Feb 17, 2009 at 1:56 AM, Matt Ettus <address@hidden> wrote:
> Woody Dickson wrote:
>>
>> Hello,
>>
>> Any know what is the cause of the following EEPROM warning? I would
>> appreciate any suggestion on how to resolve this problem.
>>
>> address@hidden usr]# usrp_siggen.py -f1
>>
>> Warning: Treating daughterboard with invalid EEPROM contents as if it
>> were a "Basic Tx."
>> Warning: This is almost certainly wrong... Use appropriate
>> burn-*-eeprom utility.
>>
>> Using TX d'board A: Flex 900 Tx MIMO B
>> Failed to set RF frequency
>>
>
>
> What do you have on the B side?
>
> Matt
>
Re: [Discuss-gnuradio] EEPROM warning, Matt Ettus, 2009/02/16
- Re: [Discuss-gnuradio] EEPROM warning,
Woody Dickson <=