[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] gr.file_source problem
From: |
slimchao |
Subject: |
Re: [Discuss-gnuradio] gr.file_source problem |
Date: |
Fri, 7 Nov 2008 01:48:12 -0800 (PST) |
Piotr Swiatkiewicz wrote:
>
> Hi,
>
> I am trying to feed samples from a file to the LFTX daughter board.
> They were recorded using usrp_rx_cfile.py (from usrp.source_c).
> I cannot see any real signal from LFTX when I run my script,
> but fftsink2.fft_sink_c produces the correct spectrum when samples
> are fed from the same file.
>
> Am I correct in my assumption that if I can see the signal at the output
> when I try usrp_siggen.py (i.e. device works) then I should also be
> getting
> signal when I feed raw samples from gr.file_source (complex) to
> usrp.sink_c?
> Is there anything else to take care about except the usual settings
> (PGA, mux, etc.) and sampling frequency that should be same as it was
> during signal capture?
>
> Thanks,
> Peter
>
>
>
>
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>
>
Hallo Peter,
I have generated some samples of a sinesoid from Matlab and want to convert
it to a binary file to the LFTX daughterboard. Can you tell me how i do to
convert it?
Thanks a lot,
Chao
--
View this message in context:
http://www.nabble.com/gr.file_source-problem-tp14183927p20377514.html
Sent from the GnuRadio mailing list archive at Nabble.com.
[Prev in Thread] |
Current Thread |
[Next in Thread] |
- Re: [Discuss-gnuradio] gr.file_source problem,
slimchao <=