|
From: | Isaac Gerg |
Subject: | Re: [Discuss-gnuradio] GNU Radio Companion USRP Transmitter Example |
Date: | Wed, 25 Jun 2008 16:33:45 -0400 |
User-agent: | Mozilla Thunderbird 1.0.7 (Windows/20050923) |
Thanks Josh,Its the end of the work day here.. so i am going to take off. I will try it first thing. The GRC I am using is from the trunk so ill just recheck it tommorrow. I am using the basic Tx and basic Rx.
Isaac Josh Blum wrote:
I just checked in an two tone loopback example to the grc trunk. The setup that I just tested it on is a usrp with basic rx and basic tx, with txa and rxa connected together.Could you post what daughter boards that you are using. You will have to use the grc trunk to use the above example.-Josh isaacgerg wrote:No luck. Can you send me an example xml schema for a transmitter that youknow works? Thanks in advanced, Isaac Josh Blum wrote:isaacgerg wrote:Does anyone have an .xml file that shows an example of doing this? Currently, I have a USRP sink with the following parameters and I cant get any signals on my Rx USRP. I know my Rx USRP is working as I can run thegnuradio ptt example and I can see energy appearing on the PSD. Here are my USRP Sink parameters: Input type: complex usint #: 0 subdev spec: side B freq: 25000000 gain 3200 mux 0x0 auto t/r : ignore tx enable: enable interp: 400 The input to the sink is a cosine wave at 10000 with amplitude 100. Thanks in advance.Im not sure about the board you are using, but the actual allowed gain parameter is way less than 3200. Set the usrp gain to 0, and try a amplitude of 5000 for the signal source.-Josh
-- address@hidden - Sr Systems Engineer Voice: 814-278-3019
[Prev in Thread] | Current Thread | [Next in Thread] |