[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] RFX2400 Failed to set RF frequency
From: |
Rana Basheer |
Subject: |
[Discuss-gnuradio] RFX2400 Failed to set RF frequency |
Date: |
Sun, 24 Feb 2008 19:38:56 +0100 |
I have installed gnuradio-3.1.1 and I am trying to run usrp_siggen.py
but it always gives "Failed to set RF frequency"
The USRP board serial number is 2059 (Marked tested on 11/20/07) and the
RFX2400 board is marked Rev 30 (12-26-2006). The RFX board is connected
to the A side of the USRP board. GNURadio is installed on Fedora 8.
For usrp_siggen.py, I am using the following options
./usrp_siggen.py -TA -f 2420 -w0
My aim is to generate a 2.42 GHz sinusoidal carrier using the RFx2400
board. Any help on resolving this issue is greatly appreciated.
Thanks and Regards
Rana Basheer
--
Posted via http://www.ruby-forum.com/.
- [Discuss-gnuradio] RFX2400 Failed to set RF frequency,
Rana Basheer <=