|
From: | George Nychis |
Subject: | Re: [Discuss-gnuradio] Problems when receiving after transmit |
Date: | Mon, 21 Jan 2008 14:02:28 -0500 |
User-agent: | Thunderbird 2.0.0.6 (X11/20071022) |
Johnathan Corgan wrote:
On 1/21/08, George Nychis <address@hidden> wrote:I have a logic analyzer and RFX2400 board handy that I can test this out. Which pin is the mixer chip enable pin?U101, pin 8.
When running usrp_rx_cfile.py the first time, i get no voltage reading from this pin.
Then I run usrp_siggen.py and get a little under 1V at the pin on average.When I stop usrp_siggen.py the pin goes down to about 200mV, which is where it stays when i run usrp_rx_cfile.py the second time.
- George
[Prev in Thread] | Current Thread | [Next in Thread] |