[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] ramping down (tx_empy continued)
From: |
Brett Trotter |
Subject: |
Re: [Discuss-gnuradio] ramping down (tx_empy continued) |
Date: |
Tue, 16 Jan 2007 11:47:23 -0800 (PST) |
So, then we have to go dac side, with ramping, and pay attention to tx_enable
as well...
I'll see what I can do.
Eric Blossom wrote:
>
> On Tue, Jan 16, 2007 at 09:54:00AM -0800, Brett Trotter wrote:
>>
>> an additional note- tested with the original firmware and ctrl+c'ing
>> still
>> leaves the sine-wave, with my new firmware, it goes away as desired..
>
> Good.
>
>> I remain perplexed as to why letting the program end normally results in
>> the
>> tx_empty not happening or the clock stopping or whatever is causing the
>> transmitter to transmit the last sample.
>
> I believe that what's happening is that when it ends normally, the
> host library disables the transmit path. When it's killed with ^C it
> just blows out and doesn't disable the transmit path (Note that the
> python code handles ^C properly)
>
> Thus, what's happening in the "normal termination" case is that the
> tx_chain is disabled, and therefore the zeros that you're inserting
> into the head of the tx signal processing path aren't being
> processed and never get to the DACs...
>
> So much for the simple solution ;)
>
> Eric
>
>
> _______________________________________________
> Discuss-gnuradio mailing list
> address@hidden
> http://lists.gnu.org/mailman/listinfo/discuss-gnuradio
>
>
--
View this message in context:
http://www.nabble.com/ramping-down-%28tx_empy-continued%29-tf3021634.html#a8397435
Sent from the GnuRadio mailing list archive at Nabble.com.