[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] DC component and daughter-boards
From: |
Damien B. |
Subject: |
[Discuss-gnuradio] DC component and daughter-boards |
Date: |
Thu, 28 Apr 2005 16:29:44 +1000 |
Hi,
Matt in a previous thread you were talking about making d/b that let
DC component pass:
> If there is enough interest, I might make such a set of boards. If someone
> else
> is interested in the design, the BasicRX/TX are a great starting point, and I
> can offer guidance.
When i'm inspecting the my FIR output, it's really difficult to
measure a 30ns (one sample) delay if the signal is not clean. Would it
be possible to make a quick but not perfect hack of the basicTX and
RX, something like:
- removing transformer
- Short-cut pin 3 to 6 and 1 to 4
the resulting impedance would be 40 Ohms (50 // 50+200+50), but is it
really bad for low freq square wave < 2MHz ?
And be sure to send a positive signal...
I dont know how the converter will deal with the DC component and the
2's complement internal encoding though.
Thanks, cheers
Damien
- [Discuss-gnuradio] DC component and daughter-boards,
Damien B. <=