[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[Discuss-gnuradio] USRP Dimensions & Co-ax Daughter Board
From: |
Iain Young - G7III |
Subject: |
[Discuss-gnuradio] USRP Dimensions & Co-ax Daughter Board |
Date: |
Tue, 1 Jun 2004 20:07:59 +0100 |
User-agent: |
Mutt/1.5.4i |
Hi All,
Just found out about the USRP, and was reading the Wiki about it, but
I couldn't find anything about the dimensions of the actual board.
Looking at the RF Sections page, I'm guessing the board must be about 115
by 130mm. Can someone confirm this ? If so, that makes it very close
to a mini-itx form factor motherboard (And gives me an idea about
mounting...)
Also, I noted one of the RF daughter boards will have dual raw co-ax
connectors. Does that mean (for example) that I could connect two sets
of downconverters, one to each connector (eg S-Band -> 144MHz -> USRP,
and K-Band -> S-Band -> 144MHz -> USRP) ?
If that is the case, can I process signals from both at the same
time ? Or do I have to select in software which connector I want to
use ? Or will the two inputs get mixed, and then I do the processing
on the combined feed ?
All the Best
Iain
- [Discuss-gnuradio] USRP Dimensions & Co-ax Daughter Board,
Iain Young - G7III <=