[Top][All Lists]
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [Discuss-gnuradio] Install problem
From: |
Paul J. Zawada |
Subject: |
Re: [Discuss-gnuradio] Install problem |
Date: |
Wed, 25 Jun 2003 21:05:55 -0500 |
I'm more of a hardware guy, so take my advice FWIW...
I think this may be a Qt compatibility problem. Even though you may
have the right version of the Qt libraries, sometimes you can't build
against them if they were compiled with a version of gcc than what
you are building. This is a problem I ran into when I built GNU
Radio on Red Hat 8.0. I don't recall the exact compile errors, but
once I downloaded the Qt source, compiled it, and reinstalled Qt, I
was able to successfully build the example programs...
Good Luck!
--zawada
At 4:11 PM -0600 6/25/03, Joseph DiVerdi wrote:
I am knee-deep in a new gnuradio install on a new system, have hit a
wall, and am seeking counsel.
The system configuration follows:
233MHz AMD K6
160MB RAM
6.4GB disk
0.5GB swap disk
RH v8.0 (gcc v3.2)
FFTW v3.0
gnuradio v0.8
configure, make, make check, and make install proceed without errors.
I am now working in the examples directory where (1) none of the
programs are built during the standard installation process and (2)
errors are thrown in response to a make manually made in the
examples directory. A representative error stream follows:
[ Ugly Details omitted ]
--
Paul J. Zawada, PE | Principal Network Research Engineer
address@hidden | National Center for Supercomputing Applications
+1 217 649 2233 | University of Illinois at Urbana-Champaign