Alan,
I thought that many of the applications for SDR had baseband bandwidths on
the order of 10MHz... how low of an IF are you looking for? Check out the
datasheet for the max2450 (http://www.maxim-ic.com/max2450) -- its an I/Q
mod/demod, but its set up for a 70MHz IF, so it won't work here.
I'm looking into a zero-IF solution, but it seems like a 10.7MHz IF
solution makes your 20Msps ADC _almost_ good enough -- how much margin
over Nyquist are you looking for? It just seems too easy to stick with
10.7 since LOs, filters, etc are sooooo cheap. I take it you really like
your ADC?
Brian.
On Wednesday, May 14, 2003, at 06:52 AM, Alan Gray wrote:
Hi all,
I've recently found that I have access to several standard radio
receivers,
including an AOR AR5000 and AR8600. Naturally, these both have a 10.7MHz
output IF and thus aren't much use in combination with my 20MSPS A/D
card
but I was wondering if anyone has looked into the possibility of adding
an
extra downconversion stage after this to obtain a usable IF.
I haven't much experience in dealing with the radio side of things, but
a
quick look at some books on the subject seem to indicate that it might
not
be too hard a circuit to put together. If anyone has looked into doing
this
or has ideas on if it will/will not work, any information would be most
welcome
Alan
<ATT645869.txt><ATT645870.txt>
---
Incoming mail is certified Virus Free.
Checked by AVG anti-virus system (http://www.grisoft.com).
Version: 6.0.480 / Virus Database: 276 - Release Date: 12/05/03