Bug.

[Saldarriaga Felix-EFS010]

Hello,

I ran the automated setup for the CYGWIN compiler. The install was a
success, but now that I am trying to run the debugger, Two things are
happening.

1st)  the debugger only shows the assembler code even if I select the Source
selection.
2nd) when I step through the code and it is at the end of it, the computer
freezes up.

I am using the NT OS. Can you please tell me what should I do to be able to
see the Source code when debugging and also for the computer not to freeze
at the end of the code. Thank you for the support.


Felix Saldarriaga
Computer Engineer II
Motorola Retail Products Division
8000 West Sunrise Blvd. Room 1C15 
Sunrise, Florida 33313
Phone: (954) 723 - 3120
Pager: (954)723 - 4567 pin 5559
Fax: (954) 723 - 8170
mailto:address@hidden